Water Damage And Mold Restoration – What Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be because of an overflow, flood or any other water damage and mold event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are 2 large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and the RIA (Restoration Industry Association) that recommends standards for water damage and mold restoration. The S500 damage as a result of water guide is the benchmark tool that is utilized by companies focusing on restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the foremost and the most important step in water damage and mold restoration. The assessment needs to be correct so that the right response can be taken. In restorating the damage caused by water, technicians and also the insurance companies must work together and understand what is damaged and how to make restoring the damage. Identifying the cause of the damage, documentation of damage, and accurate estimates are mandatory for any proper water damage and mold restoration. Categorization relies on the contamination levels of the water source. The categories are the following
Category 1 – This really is water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This really is water which includes some contaminants like water coming from a dishwasher, washer or toilet with urine.
Category 3 – This really is water which is highly unsanitary and is capable of doing causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are some examples.
Decontamination and Drying – Following the evaluation is done, the entire process of drying and decontaminating begins at the site. Based on the extent of damage, damage caused due to water can be classified into 4 types. Class 1 Damage- When loss is fixed to a small area and much less water has become absorbed by materials. This results in slow evaporation rate. Class 2 Damage – When the damage is to the whole room and carpet area. Class 3 Damage – If the entire area is saturated with water and Class 4 Damage – when there are lots of deep saturation pockets. Decontamination and drying is actually a key stage in Water damage and mold restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments have to be used. Decontamination needs to be done if contamination has been detected in the area. Decontamination may be completed for the whole area or in specific pockets where contamination has become detected.
Monitoring and Completion – Monitoring the restoration procedure of damage caused because of damage is critical to get the desired results. One must be proactive throughout the monitoring process. Checking if the drying equipment is setup properly, assessing in the event the personnel involved are qualified to do the job and checking in the event the equipments have been in working order inwtsy all portion of the monitoring process. Necessary steps should be taken if anything wrong is spotted during the monitoring process. The whole procedure for water damage restoration could be considered complete just once humidity, temperature and the moisture content is really as per industry standards. Upon completing water damage restoration process, the drying equipment can be removed.